In all heating installations, whatevertheir power is, and in any case they are managed.
No, ELESS guarantees comfort conditions equal or better. The temperature in the house is managed effectively by ELESS, and it will work to adjust temperature according to the required comfort.
Yes, the effectiveness of ELess is independent of the type of boiler and the type of fuel used. However with eless you can keep your boiler for years.
In most cases, yes. By requesting a free quote, one of our technicians will carry out a survey to analyze the specific boiler, identifying the right way to connect the device.
Absolutely No. ELess is an external control device, such as the classic thermostat, and does not affect in any way the boiler warranty.
Eless can be turned on and off at any time, you can then do a simple test: simply set up a meter reading and then disable ELess for 72 hours.
Making a second meter reading and reactivate ELess, making a final reading after another 72 hours. Proceeding to the time that it is considered necessary, the experience shows that ten days are enough to see an immediate savings. 72 hours between each measurement and the other is the right interval to help maintain comparable environmental values.
Certainly, one of our technicians configure it again according to the characteristics of the new plant.
Being an electronic device, the duration is that of its components, typically ( Not warranted ) for at least ten years.
No, the device does not require any specific maintenance.
On the contrary. The burners of the boilers are always started with great frequency; ELess causes this to happen with more regularity, with the result of a lower wear of the entire plant and, consequently, less need for maintenance.
No, on the contrary: ELess does operate the plant at a lower average temperature, avoiding too much heat (and cool down too much) the water of the radiators, with the result of a lower consumption.
Using the control probes already in the environment (ie thermostats normally used) ELess requires no other controls that causing material unnecessary jobs and aggravate the costs. The higher efficiency resides in fact, the use that is made of these instruments. The management implemented by ELess allows the environment to absorb heat from the radiators give gradually, allowing the same heat to be distributed more evenly.
Even a well-insulated house needs to be heated: ELess however optimizes the existing plant! You can still get a cost-effectiveness, and improve the living quality and significantly lower the level of pollutant emissions.
Using the principle thermal hysteresis, ELess requires the presence of material with high thermal mass, such as radiators and radiant floors.
Especially initially, it is recommended to keep the default settings of the system, in order to verify the benefits immediately. At a later stage you can always change the settings to optimize the savings or get an even more pleasant.
Of course, you will need to check if a single unit is sufficient for the entire plant or are needed more. In any case, the impact on final costs (and therefore on savings) would still be minimal.
ELess bases its operation on physical laws, for this study it was necessary a long period of development and testing on various types of equipment and building types to achieve the degree of effectiveness and efficiency today. Since 2009 ELess was applied in its final version on domestic systems, and just recently the technical developments have allowed the application on major power plants, which are the ones with most resonance.
Using the principle of hysteresis heat, air systems, unit heaters, fan coils, where the heat exchange coils are very fast, the effectiveness depends on the characteristics of the system and the savings achieved are not the same plants to large thermal mass.